| Subject: | Re: Battery light comes on above 3200 rpm |
| From: | Alistair Bell <albell@SHAW.CA> |
| Date: | Tue, 7 Apr 2020 21:59:03 -0700 |
Gregg,
The reg should be available at Napa etc. Was fairly widely used in the 80s etc Vw .
I’d slap a new one in to get home. Then think about rebuild or new alternator.
I truly feel for you, stuck on road, night etc. Take care
Alistair
> On Apr 7, 2020, at 9:54 PM, Gregg Carlen <gricha@verizon.net> wrote:
>
> Well, after my last email, which was at a gas station, got back on the road and it started acting up about 2400 rpm. Ok, getting worse.
>
> Limped at 45 mph to the next exit and checked grounds (not bad, but not great), belt tension still good, alternator brackets firm.
>
> Pulled the alternator and took out the regulator. Sure enough, one of the brushes is only about 3/8” long and the housing melted enough to just hold it in. Of course, no chance this is going back in (tried) to limp it along any further.
>
> Looks like some scoring on one of the bearing race (the short bushing one). Time for a new alternator time.
>
> Anyone near Doswell, VA with a spare alternator or regulator?
>
> Time to pack it in for the night and regroup in the morning.
>
> Thanks for the advice, guys. Narrowed it down pretty quickly.
>
> Gregg
>
>> On Apr 8, 2020, at 12:33 AM, Dennis Haynes <d23haynes57@hotmail.com> wrote:
>>
>> If you need an alternator this one works very well.
>>
>> https://www.amazon.com/Premier-Gear-PG-14778-Professional-Alternator/dp/B00KY0CWPC/ref=sr_1_2?dchild=1&keywords=vanagon+alternator&qid=1586320319&sr=8-2
>>
>> Dennis
>>
>>
>> -----Original Message-----
>> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Gene P
>> Sent: Tuesday, April 7, 2020 11:01 PM
>> To: vanagon@GERRY.VANAGON.COM
>> Subject: Re: Battery light comes on above 3200 rpm
>>
>>>> On Apr 7, 2020, at 7:31 PM, Gregg Carlen <gricha@verizon.net> wrote:
>>>
>> The belt was just recently replaced. Had about 0.5 - 1” flex in it. Could it be too tight?
>>
>> I favor the easy and the cheap. New belt run in, stretched, so it’s too loose and slips at high RPM?